Description: A two component epoxy polyamide pigmented with durable pigments giving a matt finish.
Scope: A Two pack epoxy high build coating with superb performance in severe marine & industrial environment. The product has excellent resistance to chemicals, solvents, fumes, splash & spillage. Can be used in various industries including refineries, fertilizers & other chemical plants.
Colour: Grey / RED OXIDE
24 Hours 10 days
16 Hours 6 Days
8 Hours 4 Days
Specific gravity: 1.28
Volume solids: 50
Thinner clean up: Pragati make EPOXY Thinner
Flash point: 30??C
Pack size: 5/10/20 LITERS
Application: Stir base thoroughly & then mix 4 parts of base & 1 part of catalyst by volume to uniform consistency. Allow the mixture to mature for 30 minutes & stir again before application & during use.
Brush / Roller: add up to 5% thinner if required during application.
Conventional spray: add up to 15% thinner depending on conditions. Use only standard equipment at an atomizing pressure of 3.5-4.9 Kg/cm2.
Airless spray: apply preferably without thinning. However up to 5% thinner may be added if absolutely essential depending on conditions. Use any standard equipment having pump ratio 30:1. Tip size 0.38-0.43mm.Tip pressure 110-160 Kg/cm2 .
Surface preparation: Remove grease, oil & other contaminants preferably by using degreasing solvent. Blast clean to a minimum of Sa2 ½ Swedish std SIS 05 5900. For severe corrosion, blast to Sa 3 with a surface profile not exceeding 65 microns.
The surface should be clean & dry before application of primer coat.
Storage: Up to 6 month in intact condition or sealed the containers are kept under cover in a dry place under normal temp.conditions.
FOR MORE INFORMATION CONATCT US ON :-020-65316182/8087133225